Before you leave...
Take 20% off your first order
20% off
Enter the code below at checkout to get 20% off your first order
Bore Away - Iron & Rust Stain Remover
Bore Away is a simple to use product for the removal of iron based bore water stains on brickwork, painted surfaces, glass and concrete. It is also effective on rust stains.
For the best results thoroughly wet brink and masonry surfaces that you are looking to clean. Mix 1 part Bore Away to 1 part Warm Water, brush mix on and leave for up to 30 minutes making sure it doesn’t dry on the surface. Then rinse it off thoroughly.
For painted or glass surfaces, as per the above instructions, although you can dilute the product to 1 part Bore Away to 2 parts warm water.
Re-apply is necessary.
This product may not remove very old stains and if more effective on newer stains.
FIRST AID: If poisoning occurs contact poison information centre immediately. If swallowed DO NOT induce vomiting. Give plenty of water and seek medical advice. If in eyes, flush with water for at least 15 minutes and seek medical advice.
SAFETY DIRECTIONS: Keep out of reach of children. Avoid contact with eyes.
Free shipping for deliveries within Perth Metro on orders over $100 Under $100 Perth Metro area $15 shipping on orders or the option of Auspost
Nationally we offer free shipping on all orders over $200, unless they are over 20kg then we offer some fixed rate options, please select these when they appear to avoid being contacted for extra freight charges.
Freight rates for regional areas will need to be confirmed prior to dispatch. Regional areas are defined by our shipping companies.
Orders over 20kg we will endeavour to fit within the above shipping prices where possible, if not we will email you to discuss the options prior to shipping.
I used the product at 1:1, painted it on and washed it off about a minute later. Nothing happened. Nothing.
Hi Tim,
If you every have an issue with any of our products please reach out we are always happy to help.
Bore Away at a 1:1 ratio needs about half an hour on the surface to work and you must not let it dry. If you would like it to work quicker try it straight but you will also need to leave it for about 5 minutes. You also need to scrub it.
Unfortunately it is not a miricle probuct but does work well when used as above.
I had bore stain in Hardy fence Applied by instruction but never worked , applied the same product pvc drain pipe to remove bore stain but failed wasted my $70.
Hi Gopi, If you every have an issue with any of our products please reach out we are always happy to help.
I have never tried this on Fibre Cement sheeting but I would advise as its quite porous to try it straight. Leave it for about 5 minutes. You also need to scrub it.
As for PVC we have had great sucess with it. I feel you havent left it on the surface long enough
We tried many ways to eliminate the rust stains on our driveway. We stumbled upon this product on the internet and found Bore-away an outright success, with little or no effort to carry out the task.
We just bought the bore away to clean the stains on our exposed aggregate floor. We had stains from the potting mix. It was wonderful to see this restored the original surface. Highly recommended for cleaning stains.
Thank you Dale for showing care for my lawn. While delivering bore stain remover noticed worm damage in my lawn that I was totally unaware of. Couple of phone calls later and advice we were right on top of it…👍
Thanks for subscribing!
This email has been registered!
Take 20% off your first order
Enter the code below at checkout to get 20% off your first order